Installation Guide User Manual

Linx Installation for Model 424 Automotive Dynamometers

424 LINX INSTALLATION

Pulley Mounting Plates and Outer Bearings Installation

INSTALLING THE STATIONARY DYNO PULLEY OUTER BEARING, BEARING MOUNTING PLATE,

AND LOWER PULLEY MOUNT

1 Secure the outer stationary dyno pulley bearing to the stationary dyno pulley

bearing plate using four 9/16-12 x 2-inch bolts, four 9/16-inch flat washers, and

four 9-16-inch nuts. Slide this assembly onto the stationary dyno pulley outer

shaft.

Figure 23: Install the Outer Stationary Dyno Pulley Bearing and Bearing Plate

2 Place a lower stationary dyno pulley mount (P/N 61300023) under the stationary

dyno pulley and loosely secure the mount to the inner plate using

five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers (one of the holes on the

pulley mount is not used).

3 Loosely secure the pulley mount to the stationary dyno pulley bearing plate using

five 3/8-16 x 1-inch bolts and five 3/8-inch flat washers.

Figure 24: Secure the Pulley Mount Under the Stationary Dyno Pulley

XD061

stationary dyno

pulley bearing

stationary dyno

pulley bearing plate

stationary dyno

pulley

XD062

pulley mount

P/N61300023

stationary dyno

pulley bearing plate