Installation Guide User Manual

424 LINX INSTALLATION
Above Ground Covers
Version 6 Linx Installation for Model 424 Automotive Dynamometers
33
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ABOVE GROUND COVERS
You will need the following parts:
• 21200095 Belt Cover, End Panel (2)
• 21200097 Belt Cover, Top (2)
• 21400006 Belt Cover, Leg (8)
• 21600026 Belt Cover, Center Support
• 36561045 Screw, 1/4-20 x 5/8", Pan-Head, Torx (64)
• 61100013 Belt Cover, Front Panel Assembly (2)
• DM150-020-005 Nut-Crush, 1/4-20 (8)
1 Place the tops flange side up on the floor.
2 Secure two legs in the corners of each top as shown using four 1/4-20 x 5/8-inch
torx screws each.
3 Secure one leg in the middle of each top as shown using two 1/4-20 x 5/8-inch
torx screws each.
4 Secure one leg in the corner of each top as shown using two 1/4-20 x 5/8-inch torx
screws each.
5 Secure each end panel using six 1/4-20 x 5/8-inch torx screws.
Figure 29: Install the Legs and End Panels
XD090
end panel