Installation Guide User Manual

424 LINX INSTALLATION
Above Ground Covers
Version 6 Linx Installation for Model 424 Automotive Dynamometers
35
8 Remove the 1/4-20 x 5/8-inch torx screw from the outer most tube of the dyno
bridge.
9 Turn the cover assembly over and move towards the dyno. Place the cover so the
center support is on the outer tube with the hole lined up as shown.
10 Secure the cover assembly to the dyno using the 1/4-20 x 5/8-inch torx screw
removed earlier.
Figure 31: Secure the Cover Assembly to the Dyno
XD093
center support