Installation Guide Instruction Manual

STATIONARY DYNO UPGRADE
Air Fittings Upgrade
Version 7 In Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
C-3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
AIR FITTINGS UPGRADE
Before the stationary dyno can be used with the 4WD dyno, the existing air fittings on
the stationary dyno must be upgraded.
1 Remove the existing air inlet fitting from the brake solenoid assembly.
2 Install the street tee.
3 Replace the air inlet fitting removed earlier.
4 Install a barbed hose fitting into the street tee.
5 Remove the existing plug from the air can.
6 Install one 3/8-1/4-inch bushing and elbow fitting.
7 Continue with installing the 4WD dyno in Chapter 3.
Figure C-2: Upgrade the Air Fittings
AD141
existing air inlet fitting
brake solenoid
assembly
street tee
barbed hose fitting
bushing and
elbow fitting