Installation Guide Instruction Manual

In Ground Model 424x/424xLC

Automotive Dynamometer Installation Guide

CHAPTER 2

Dyno Installation

2-12

ANCHORING THE DYNO

Dynojet recommends you secure your dyno to the floor in your dyno room using

concrete anchors. Use the following instructions to secure the dyno to the floor.

You will need the following parts:

• 36923100 Washer, 3/8", Hardened, Flat, Steel (4)

• 37513200 Anchor, Redhead, 3/8" (4)

• 37518200 Redhead Anchor Installation Tool

• DM150-019-012 Bolt, 3/8-16 x 1", Hex (4)

1 Using the mounting feet as a template, mark and drill each hole needed to secure

the four dyno feet to the floor.

2 Install four Red Head anchors. Refer to Appendix A for installation instructions.

3 Secure each mounting foot to the floor using one 3/8-16 x 1-inch hex-head bolt

and one 3/8-inch flat washer.

Figure 2-5: Secure the Dyno to the Floor

INSTALLING THE EDDY CURRENT BRAKE

Refer to Chapter 4 for eddy current brake installation instructions and install your

eddy current brake at this time.

AD137

secure dyno to floor