Installation Guide Instruction Manual

4WD DYNO INSTALLATION

Track Assembly

Version 7 In Ground Model 424x/424xLC

Automotive Dynamometer Installation Guide

3-7

INSTALLING THE TRACK ASSEMBLY

Once all the holes are marked and drilled, install the track assembly.

You will need the following parts:

• 21514282 Rail (2)

• 21716400 Rail Tie (3)

• 31619500 Rail Clip (10)

• 36582471 Bolt, 3/8-16 x 1.5", Flange-Hex (10)

• 61314300 Rail Tie Assembly (2)

• 61314700 Rail Clamp (4)

1 Layout the first and last rail tie assemblies and the rail ties. Use the holes you

marked and drilled for placement of the rail tie assemblies and rail ties.

Note: The first rail tie has four holes for securing the cable track assembly. Verify

this rail tie assembly is closest to the stationary dyno.

2 Place the rail clamps over the rails.

3 Place the rails into the rail tie assemblies.

Note: For clarity, the pit and stationary dyno are not shown.

Figure 3-3: Install the Track Assembly

AD045

rail clamps

rail

first rail tie

assembly

last rail tie

assembly

rail tie

holes for cable

track assembly