Installation Guide Instruction Manual

In Ground Model 424x/424xLC

Automotive Dynamometer Installation Guide

CHAPTER 3

Bridge Installation—4WD Dyno

3-40

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

BRIDGE INSTALLATION—4WD DYNO

This section will walk you through installing the drum guards, runner mounts, runner

assemblies, cover, and runner tie straps.

You will need the following parts:

• 21214701 Runner Tie Strap (2)

• 21214702 Runner Clamp, Short (2)

• 21214705 Runner Tie Slide (2)

• 21216101 Drum Guard, Right

• 21216102 Drum Guard, Left

• 21216103 Drum Guard, Rear

• 21219512 Bridge Cover, 4WD Dyno

• 21514801 Runner Mount, Short (2)

• 36561045 Screw, 1/4-20 x 5/8", PH, Torx, Black (14)

• 36582034 Bolt, 3/8-16 x 1.25", Button-Head, Flange, Allen (3)

• 36582471 Bolt, 3/8-16 x 1.5", Flange-Hex (6)

• 36588071 Bolt, 3/8-16 x 5", Black Oxide (14)

• 36923100 Washer, 3/8", Hardened, Flat, Steel (14)

• 36932100 Washer, 3/8", Splitlock, Steel (14)

• 61319500 Runner Assembly (14)

• DM150-011-004 Nut, 3/8-16, Hex (14)