Installation Guide Instruction Manual

In Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
CHAPTER 3
Bridge Installation—4WD Dyno
3-42
INSTALLING THE RUNNER MOUNTS
The runner mounts and runner clamps are shorter for the moveable dyno.
1 Place the runner mount (z-shaped) with seven round holes on top of the drum
guard.
2 Place the runner clamp plate with seven round holes on top of the runner mount.
3 Loosely secure each runner mount and runner clamp to the dyno using three
3/8 x 1.5-inch flange hex allen bolts.
Figure 3-29: Install the Runner Mounts
AD385
runner clamp
runner mount
drum guard