Installation Guide Instruction Manual

In Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
CHAPTER 4
Eddy Current Brake Installation
4-6
INSTALLING THE TEMPERATURE SENSOR
Use the following instructions to secure the temperature sensor to the eddy current
brake in the location shown.
You will need the following part:
• 76955001 Temperature Sensor Assembly
Figure 4-5: Temperature Sensor Location
1 Remove the nut from the sensor.
2 Slide the sensor through the cross brace.
3 Secure the sensor to the brace using the nut removed earlier.
Note: For clarity, the side panel has been removed.
Figure 4-6: Install the Temperature Sensor
temperature sensor
sensor
remove nut
nut
cross brace