Installation Guide Instruction Manual

EDDY CURRENT BRAKE INSTALLATION
Eddy Current Brake Installation
Version 7 In Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
4-7
INSTALLING THE BEARING, SPLINE SHAFT, AND DRIVELINE ASSEMBLY
The eddy current brake can be installed on either side of your dyno, the installation
instructions are the same.
You will need the following parts:
• 22117130 Splined Shaft Assembly
• 32355056 Bearing
• 36801080 Bolt, 1/2-13 x 1.5", Flange-Hex (2)
• 62240130 Driveline Assembly
1 Install the bearing using two 1/2-13 x 1.5-inch flange-hex bolts. Leave the bolts
loose.
Figure 4-7: Install the Bearing
EB160
bearing
bolt