Installation Guide Instruction Manual

EDDY CURRENT BRAKE INSTALLATION

Pit Covers

Version 7 In Ground Model 424x/424xLC

Automotive Dynamometer Installation Guide

4-13

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

PIT COVERS

Before installing the eddy current brake pit covers, verify all cables have been routed

and you have completed the 4WD dyno installation. Refer to “Cable Routing” on page

3-12 for more information.

You will need the following parts:

• 21217513 Calibration Cover (2)

• 21919101 Foot (6)

• 36561045 Screw, 1/4-20 x 5/8", Pan-Head, Torx (12)

• 36582477 Bolt, 3/8-16 x 1.5", Hex (8)

• 37513200 Anchor, Redhead, 3/8" (8)

• 37518200 Redhead Anchor Installation Tool

• 61319507 Support Leg

• 61329400 Pit Cover, Retarder (2)

• DM150-011-002 Washer, 3/8", Flat (8)

• DM150-019-012 Bolt, 3/8-16 x 1", Hex (8)

1 Install three feet using one 3/8-16 x 1-inch hex bolt each to the pit cover.

2 Install the support leg using one 3/8-16 x 1-inch hex bolt to the pit cover.

3 Install three feet to the remaining pit cover using one 3/8-16 x 1-inch hex bolt

each.

Figure 4-14: Install the Feet and Leg to the Pit Cover

AD446

pit cover

foot

leg