Installation Guide Owner's manual
Table Of Contents
- Cover
- Copyright
- Table of Contents
- Warnings
- 1 - Specifications and Operating Requirements
- 2 - Stationary Dyno Installation
- 3 - 4WD Dyno Installation
- Unpacking and Inspecting the Dyno
- Track Assembly
- Dyno Installation
- Cable Routing
- Identifying the Cables
- Routing the Cables—Without the Eddy Current Brakes
- Wiring the Breakout Board—Without the Eddy Current Brakes
- Routing the Cables—With One Eddy Current Brake
- Wiring the Breakout Board—With One Eddy Current Brake
- Routing the Cables—With Two Eddy Current Brakes
- Wiring the Advanced Breakout Board—With Two Eddy Current Brakes
- Hydraulic Movement Installation
- Air Can Sleeve
- 4WD Dyno Movement Test
- Bridge Installation—Stationary Dyno
- Bridge Installation—4WD Dyno
- Deck Installation
- Logo Panel Installation
- 4 - Eddy Current Brake Installation
- Eddy Current Brake Installation
- Before Installing the Eddy Current Brake: Verify Optimal Brake Cooling
- Before Installing the Eddy Current Brake: Verify Mounting Holes
- Unpacking the Eddy Current Brake
- Installing the Temperature Sensor
- Installing the Bearing, Splined Shaft, and Driveline Assembly
- Installing the Eddy Current Brake
- Installing the Load Cell
- Installing the Front and Rear Brake Covers and Theta Controller
- Torque Module Installation
- Load Cell Calibration
- Eddy Current Brake Installation
- 5 - Side Deck Assembly Installation
- 6 - Basic Dyno Operation
- A - Red Head Anchor Installation
- B - Power Requirements and Installation
- C - Stationary Dyno Upgrade
- D - Bridge Extension Assembly
- E - Interface Roller Assembly Installation
- F - Torque Values
- Index
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
CHAPTER 1
Introduction
1-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INTRODUCTION
Before installing your dyno, please take a moment to read this guide for installation
instructions, dyno features, and other important information. This guide is designed
to be a reference tool in your everyday work and includes the following chapters and
information:
SPECIFICATIONS AND OPERATING REQUIREMENTS
This chapter describes the specifications and requirements for the dyno.
STATIONARY DYNO INSTALLATION
This chapter describes the procedures for installing the stationary dyno.
4WD DYNO INSTALLATION
This chapter describes the procedures for installing the 4WD dyno.
EDDY CURRENT BRAKE INSTALLATION
This chapter describes the procedures for installing the eddy current brake, torque
module, and load cell. This chapter also includes the procedures for load cell
calibration.
SIDE DECK ASSEMBLY INSTALLATION
This chapter describes the procedures for installing the side deck assembly.
BASIC DYNO OPERATION
This chapter describes basic dyno operating procedures and maintenance.
RED HEAD INSTALLATION
This appendix describes the procedures for installing the Red Head anchors.
POWER REQUIREMENTS
This appendix describes the power requirements and installation instructions for the
eddy current brake.
STATIONARY DYNO UPGRADE
This appendix describes the procedures for upgrading an existing stationary dyno to
be used with the 4WD dyno.
BRIDGE EXTENSION ASSEMBLY
This appendix describes the procedures for installing the bridge extension assembly.
INTERFACE ROLLER ASSEMBLY INSTALLATION
This appendix describes the procedures for installing the interface roller assembly.
TORQUE VALUES
This appendix describes the standard and metric torque values.