Installation Guide Owner manual

CHAPTER 3
Track Assembly
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
3-8
4 Loosely install the ten rail tie clips using one 3/8-16 x 1.5-inch flange-hex bolt per
clip. There are five rail tie clips on each side of the track assembly.
5 Verify the track assembly is square and make any necessary adjustments.
6Tighten all ten bolts.
Note: For clarity, the stationary dyno is not shown.
Figure 3-3: Install the Rail Tie Clips
AD103
bolt
rail tie clip
rail
anchor in floor
rail tie