Installation Guide Owner manual

3-23
4WD DYNO INSTALLATION
Hydraulic Movement Installation
Version 1 Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
HYDRAULIC MOVEMENT INSTALLATION
Use the following instructions to install the hydraulic movement.
You will need the following parts:
• 26100000 Spacer, 424 Hydraulic Movement (2)
• 32900000 Clevis Pin, 3/4 x 4.5" (2)
• 32904080 Hairpin Cotter, 7/16 x 3/4" (2)
• 36582471 Bolt, 3/8-16 x 1.5", Flange-Hex (2)
• 37513200 Anchor, Redhead, 3/8" (2)
• 61300016 Cylinder Mount, Dyno
• 61300061 Cylinder Mount, Floor
• DM150-011-002 Washer, 3/8", Flat (4)
• DM150-019-012 Bolt, 3/8-16 x 1", Hex (4)
1 Secure the dyno cylinder mount to the dyno using two 3/8-16 x 1.5-inch bolts.
Figure 3-12: Secure the Dyno Cylinder Mount to the Dyno
AD346
dyno cylinder mount