Installation Guide Owner manual

3-29
4WD DYNO INSTALLATION
Hydraulic Movement Installation
Version 1 Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
WIRING THE HYDRAULIC MOTOR
Verify the motor is wired for your needs. The motor is wired for 110V but can be
changed to 220V.
1 Remove the wiring box cover.
2 Follow the instructions on the cover to wire the motor for 220v. Refer to the
Hydraulic Movement Wiring Diagram in Figure 3-19 on page 3-30.
Figure 3-18: Wiring the Hydraulic Motor
A558D
wiring box cover