Installation Guide Owner manual

CHAPTER 3
Bridge Installation—4WD Dyno
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
3-44
INSTALLING THE COVER AND RUNNER TIE STRAPS
1 Secure the cover to the runner mounts using the two reserved bolts from earlier.
2 Secure the cover to the runner assemblies using two 1/4 x 5/8-inch torx head
bolts.
3 Secure one runner tie strap and one plastic runner tie slide to each set of moveable
runner assemblies using six 1/4 x 5/8-inch torx head bolts each.
Figure 3-30: Install the Cover and Runner Tie Straps
A618
D
1/4 x 5/8-inch torx
head bolt
cover
reserved bolts
runner tie strap
runner tie slide