Installation Guide Owner manual

CHAPTER 3

Deck Installation

Above Ground Model 424x/424xLC

Automotive Dynamometer Installation Guide

3-46

1 Verify the drum guards are installed. Refer to page 3-41 for installation

instructions.

2 Verify the front and rear eddy current brake covers are installed. Refer to page 4-

16 for installation instructions.

3 Install the deck brace mounting bracket using two 3/8-16 x 1.5-inch flange hex

bolts.

Note: If you do not have an eddy current brake, you will need to install one deck

mounting bracket on each side of the dyno.

Figure 3-31: Install the Deck Brace Mounting Bracket

A619

mounting bracket