Manual

AIR FUEL RATIO MODULE AND COMPRESSED AIR PUMP INSTALLATION
Compressed Air Pump Assembly
Version 5 Compressed Air Air Fuel Ratio Module Installation and User Guide
1-9
INSTALLING THE PUMP ASSEMBLY ON THE STAND
Use the following instructions to install the pump assembly on the stand. Refer to
Appendix A for on-board dyno installation instructions.
1 Open the toggle clamp and slide the pump assembly on the upright.
2 Close the toggle clamp to secure the pump in place.
3 Secure the sensor(s) to the pump assembly.
Note: Make sure the sensor is on top.
4 Attach the compressed air line to the solenoid.
Note: The compressed air must be clean and dry, 100 psi or greater.
5 Attach the silicone tube(s) to the sensor block.
Note: The length of the silicone tube can be adjusted for your application.
6 Attach the copper sample tube(s) to the silicone tube(s).
Figure 1-6: Installing the Pump Assembly on the Stand
sensor
attach compressed air
toggle clamp
upright
silicone tube
attach power cable
copper sample tube