Installation Guide

ManualsBrandsDynojet ManualsPower CommanderDYNOJET PC6-16017 Power Commander 6

POWER COMMANDER 6

1 POWER COMMANDER 6

1 INSTALLATION GUIDE

1 USB CABLE

2 DYNOJET DECALS

2 POWER COMMANDER DECALS

2 VELCRO STRIPS

1 ALCOHOL SWAB

1 POSI-TAP

PARTS LIST

IPC6-16017.01

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.

THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.

Installation Guide for: PC6-16017

Model coverage: 2009-2022 Honda VT750 Models

Summary of content (6 pages)

PAGE 1
POWER COMMANDER 6 Installation Guide for: PC6-16017 Model coverage: 2009-2022 Honda VT750 Models PARTS LIST 1 POWER COMMANDER 6 2 POWER COMMANDER DECALS 1 INSTALLATION GUIDE 2 VELCRO STRIPS 1 USB CABLE 1 ALCOHOL SWAB 2 DYNOJET DECALS 1 POSI-TAP PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION. THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION. IPC6-16017.
PAGE 2
INPUT ACCESSORY GUIDE USB CONNECTION INPUT 1 EXPANSION PORTS 1 & 2 INPUT 1 GRD INPUT 2 INPUT 2 GRD SPEED ANALOG CRANK OPTIONAL ACCESSORY INPUTS Map (Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important. Shifter (Input 1 or 2) Used for clutch-less full throttle upshifts.
PAGE 3
INSTALLING THE POWER COMMANDER 6 1 Remove the seat and fuel tank. Removing the fuel tank is tricky since there is not a dry-break on the fuel line to the fuel pump. Either drain the fuel or have someone hold the fuel tank up while performing the install. 2 Lay the PC6 in the battery area and route the harness up the right side of the frame following the stock wiring harness. 3 Unplug the stock wiring harness from each injector. 4 Plug the PC6 harness in-line of stock wiring harness and each injector.
PAGE 4
7 Locate the rear ignition coil behind the right hand side cover. 8 Unbolt this coil so that the bottom wires can be accessed. 9 Unplug the BLACK/WHITE and YELLOW/BLUE wires from the coil. 10 Plug the set of RED colored wires of the PC6 in-line with the BLACK/WHITE coil wire and the coil. 11 Plug the set of BLUE colored wires of the PC6 inline with the YELLOW/BLUE coil wire and the coil. 12 Bolt the rear coil back to its mounting bracket.
PAGE 5
15 Locate the front ignition coil on the left hand side of the bike above the front cylinder head. 16 Unplug the BLUE/YELLOW wire from the coil. 17 Plug the set of GREEN colored wires of the PC6 inline with the BLUE/YELLOW wire and the coil. 18 Remove the battery tray lid. 19 Attach the ground wire from the PC6 to the negative side of the battery. 20 Reinstall battery tray lid making sure it does not pinch the ground wire.
PAGE 6
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.