Installation Guide

PC6-16017
INSTALLING THE POWER COMMANDER 6
1 Remove the seat and fuel tank.
Removing the fuel tank is tricky since there is not a
dry-break on the fuel line to the fuel pump. Either
drain the fuel or have someone hold the fuel tank up
while performing the install.
2 Lay the PC6 in the battery area and route the harness
up the right side of the frame following the stock
wiring harness.
3 Unplug the stock wiring harness from each injector.
4 Plug the PC6 harness in-line of stock wiring harness
and each injector.
The ORANGE colored wires from the PC6 go to the
front cylinder.
The YELLOW colored wires from the PC6 go to the
rear cylinder.
5 Locate the Throttle
Position Sensor connector
on top of the throttle body.
This is a BLACK 5-pin
connector.
6 Using the supplied posi-
tap secure the GREY wire
from the PC6 harness to
the RED/YELLOW wire.