Installation Guide

4 2009-2022 HONDA VT750 MODELS
INSTALLATION GUIDE
7 Locate the rear ignition coil behind the right hand
side cover.
8 Unbolt this coil so that the bottom wires can be
accessed.
9 Unplug the BLACK/WHITE and YELLOW/BLUE wires
from the coil.
10 Plug the set of RED colored wires of the PC6 in-line
with the BLACK/WHITE coil wire and the coil.
11 Plug the set of BLUE colored wires of the PC6 in-
line with the YELLOW/BLUE coil wire and the coil.
12 Bolt the rear coil back to its mounting bracket.
13 Locate and unplug the Crank Position Sensor
connectors on the right hand side of the bike, up by
the steering stem.
This is the set of RED, 2-pin connectors.
14 Plug the set of RED, 2-pin connectors of the PC6
wiring harness in-line with the bike’s Crank Position
Sensor connectors.