Installation Guide

ManualsBrandsDynojet ManualsPower CommanderDYNOJET PC6-16035 Power Commander 6

1 POWER COMMANDER 6

1 INSTALLATION GUIDE

1 USB CABLE

2 DYNOJET DECALS

2 POWER COMMANDER DECALS

2 VELCRO STRIPS

1 ALCOHOL SWAB

1 POSI-TAP

PARTS LIST

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.

THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.

IPC6-16035.01

POWER COMMANDER 6

Installation Guide for: PC6-16035

Model Coverage: 2002-2008 Honda VTX1800 Models

Summary of content (6 pages)

PAGE 1
POWER COMMANDER 6 Installation Guide for: PC6-16035 Model Coverage: 2002-2008 Honda VTX1800 Models PARTS LIST 1 POWER COMMANDER 6 2 POWER COMMANDER DECALS 1 INSTALLATION GUIDE 2 VELCRO STRIPS 1 USB CABLE 1 ALCOHOL SWAB 2 DYNOJET DECALS 1 POSI-TAP PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION. THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION. IPC6-16035.
PAGE 2
INPUT ACCESSORY GUIDE USB CONNECTION INPUT 1 EXPANSION PORTS 1 & 2 INPUT 1 INPUT 2 INPUT 2 SPEED ANALOG CRANK OPTIONAL ACCESSORY INPUTS Map (Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important. Shifter (Input 1 or 2) Used for clutch-less full throttle upshifts.
PAGE 3
INSTALLING THE POWER COMMANDER 6 1 Remove the seat. 2 Remove the air box assembly. 3 Remove the fuel tank. 4 Remove the left side cover. 5 Remove the chrome cosmetic engine cover on the left side of the engine directly below the key switch. 6 Using the supplied Velcro, secure the PC6 module behind the left side cover at the location shown. Clean both surfaces with the supplied alcohol swab prior to applying the Velcro.
PAGE 4
10 Route the remainder of the PC6 wiring harness towards the right hand side of the bike, through the frame, under the fuel tank, and towards the throttle bodies while following the stock wiring harness on the right hand side of the frame as closely as possible. Make sure the wiring harness is free and clear of any hot or moving parts and that none of the wires will get cut or pinched when the fuel tank is reinstalled. We recommend routing the wiring harness behind the rear coil.
PAGE 5
16 Locate the Rear Ignition Coil on the right side of the frame. 17 Unplug the stock YELLOW/BLUE wire from the ignition coil’s GREEN spade terminal. 18 Plug the pair of BLUE colored wires of the PC6 in-line of the Rear Ignition Coil’s GREEN spade and the stock YELLOW/BLUE wire. 19 Locate the Front Ignition Coil of the forward left side of the frame. 20 Unplug the BLUE/YELLOW wire from the ignition coil’s GREEN spade terminal.
PAGE 6
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.