Installation Guide

PC6-16035
1 Remove the seat.
2 Remove the air box assembly.
3 Remove the fuel tank.
4 Remove the left side cover.
5 Remove the chrome cosmetic engine cover on the left
side of the engine directly below the key switch.
6 Using the supplied Velcro, secure the PC6 module
behind the left side cover at the location shown.
Clean both surfaces with the supplied alcohol swab
prior to applying the Velcro.
7 Locate and unplug the stock wiring harness from the
bike’s Crank Position Sensor.
This is a WHITE 2-pin connector located inside the
rubber boot behind the cosmetic chrome left side
engine cover.
8 Plug the PC6 wiring harness in-line of the stock Crank
Position Sensor connectors.
9 Reinstall the left side engine cover, making sure the
wires do not get pinched.
INSTALLING THE POWER COMMANDER 6