POWER COMMANDER 6 Installation Guide for: PC6-22091 Model coverage: 2002-2009 Yamaha XV1700 Road Star Warrior PARTS LIST 1 POWER COMMANDER 6 2 POWER COMMANDER DECALS 1 INSTALLATION GUIDE 2 VELCRO STRIPS 1 USB CABLE 1 ALCOHOL SWAB 2 DYNOJET DECALS PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION. THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION. PC6-22091.
INPUT ACCESSORY GUIDE USB CONNECTION INPUT 1 EXPANSION PORTS 1 & 2 INPUT 1 GRD INPUT 2 INPUT 2 GRD SPEED ANALOG CRANK OPTIONAL ACCESSORY INPUTS Map (Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important. Shifter (Input 1 or 2) Used for clutch-less full throttle upshifts.
INSTALLING THE POWER COMMANDER 6 1 Remove the seat. Remove the two nuts at the rear of the fuel tank. 2 Remove the left hand cosmetic cover (chrome triangle cover that looks like an airbox). 3 To remove the fuel tank release the two drybreaks. Do not cut the metal bands around the fuel lines to remove. 4 Remove the fuel tank. 5 Remove the airbox. DISCONNECT FUEL LINES To remove, unscrew the two bolts. Also loosen the clamp screw at the intake snorkel.
INSTALLING THE POWER COMMANDER 6 7 Unplug the BLACK 4-pin connector for the fuel injectors. 8 Unplug the BLACK 3-pin connector for the Throttle Position Sensor. UNPLUG STOCK HARNESS 9 Plug the connectors from the PC6 in-line of the stock wiring harness. CONNECT IN-LINE 10 Locate the stock ground. Follow the negative battery cable to the frame. Remove the allen bolt that secures the ground cable to the frame.
INSTALLING THE POWER COMMANDER 6 11 Plug the pair of RED/WHITE wires on the PC6 wiring harness in-line of the right side Ignition Coil and the stock BLACK/RED wire. 12 Plug the GREEN wire of the PC6 to the stock BLACK/WHITE wire and plug the WHITE/GREEN wire of the PC6 to the right side Ignition Coil. 13 On the left side Ignition Coil at the front of the bike, unplug the stock BLACK/ORANGE wire from the Ignition Coil.
INSTALLING THE POWER COMMANDER 6 17 Plug the pair of connectors from the PC6 with BROWN colored wires in-line of the stock Crank Position Sensor connectors. 18 Reinstall the bike’s ECU back into its original location. CONNECT TO CPS 19 Using the supplied Velcro, attach the PC6 to the top of the ECU. Use the alcohol swab to clean both surfaces before attaching. 20 Reinstall the cover, fuel tank, and seats. Download the latest map files from our web site at dynojet.com/tunes.
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.