Instruction Manual

Model SD12 Scooter Dynamometer Installation Guide
CHAPTER 2
Installation
2-4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION
Use the following steps to install the scooter dyno.
You will need the following parts:
•Drum
•Front Support
•Ramp
• 197104130 Cable Tie, 4" (2)
• 22100011 Axle Shaft (2)
• 32800000 Retaining Ring, 1/2" (4)
• 36561045 Screw, 1/4-20 x 5/8", Pan-head, Torx (2)
• 71300003 Wheel Clamp
INSTALLING THE FRONT SUPPORT
1 Place the front support on the drum.
Figure 2-2: Place Front Support on the Drum
SD003
drum
front support