Installation Guide User guide

Model SD12 Scooter Dynamometer Installation Guide
CHAPTER 3
Loading the Vehicle
3-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LOADING THE VEHICLE
Use the following steps to load a vehicle on the dyno.
Risk of injury. Always wear proper eye and ear protection when operating the
dyno.
1 Verify your computer is running.
2 Verify the wheel clamp is at the front of the front support.
Lift the spring plunger to slide the wheel clamp to a different position. Release
the spring plunger to lock the wheel clamp in the new position.
3 Drive the vehicle onto the dyno and align the vehicle straight with the dyno.
4 Stop the vehicle when the drive axle is centered on the drum.
5 When the vehicle is positioned properly on the dyno, shut the engine off.
• If the vehicle has an automatic transmission, apply the parking brake.
• If the vehicle has a manual transmission, place it in gear.
6 Slide the wheel clamp up to the front tire of the vehicle.
Lift the spring plunger to slide the wheel clamp to a different position. Release
the spring plunger to lock the wheel clamp in the new position.
7 Turn the wheel clamp handle until the front tire is held securely in the wheel
clamp.
Figure 3-1: Load the Vehicle
slide the
wheel clamp
center drive axle
on dyno drum
wheel clamp
handle