Owner manual

Document #98263100
3
Step 4
Attach the new sprocket ends to the dyno.
• Put one
1
/
2
" x 4
1
/
2
" bolt with a
7
/
16”
flat washer through each
sprocket end and the rear hole in the dyno arms. Fasten loosely.
• Allow the sprocket ends to hang as in the picture below.
• Pull the chains straight down and tightly against the hanging
sprockets.
• Swing both sprocket ends on the shaft up and put in the front
1
/
2
" x 4
1
/
2
" bolts with
7
/
16”
flat washers.
Important:
Make sure that the gears on the sprockets are in the chain at
the same point on both sides!!