Assembly Instruction Manual

SPRING APPLIED AIR RELEASE (SAAR) BRAKE ASSEMBLY INSTALLATION

Installing the SAAR Brake Assembly

Version 1 Spring Applied Air Release (SAAR) Brake Assembly Installation

5 While lowering the air can through the hole in the tube, align the air can studs

with the holes in the bracket.

Note: The rod will not extend all of the way through the tube until the electronics

are connected and air pressure is applied to the air can.

6 Loosely attach the air can to the bracket using the two 5/8" nuts and lockwashers

removed earlier.

Keeping the nuts loose will allow for adjustment while extending the air can rod

the remaining distance through the tube. The power and air connections are

necessary to finish connecting the brake assembly.

Figure 18: Install the Air Can

BR029

use 5/8" lockwashers

and nuts to attach air

can to bracket

insert air can rod into

hole through tube

washer and upper nut

will be tightened down

onto tube after lower

nut is fastened

air can studs