Assembly Instruction Manual

SPRING APPLIED AIR RELEASE (SAAR) BRAKE ASSEMBLY INSTALLATION
The Hydraulic Brake Assembly
Version 1 Spring Applied Air Release (SAAR) Brake Assembly Installation
5
PREPARING TO REMOVE THE HYDRAULIC BRAKE
1 Turn off the power and unplug the dyno electronics and observe all applicable
safety procedures.
2 Shut off and release the air pressure to the air pressure regulator.
3 Remove covers as necessary to provide yourself good access to the braking
components. Refer to your dyno manuals, if necessary, to review removing the
covers. You can download copies of the manuals for your dyno from
www.dynojet.com.
4 Disconnect the 3/8-inch air hose from the fitting on the pressure regulator, or cut
off the existing air hose close to the fitting on the pressure regulator.
Note: Leave the air hose with the dyno as you will reconnect it to the new
pressure regulator for the SAAR Brake Assembly.