Installation Guide Manual

EFIS-D10 Installation Manual
EFIS-D10 Installation Guide Doc Num: 100006-000 Rev. C
9/11/2003 Page 5 of 24
INTRODUCTION
The information presented in this manual pertains to the physical mounting of the EFIS-D10
electronic flight information system, the optional EDC-D10 Electronic Digital Compass, and the
optional Dynon Avionics Pitot tube. Because some of the components mentioned above are
optional, and you may not have purchased all the components, you need only read through the
relevant sections of this guide. Information about the operation of the EFIS-D10 and can be
found in the EFIS-D10 User’s Guide
DESCRIPTION
The EFIS-D10 is a flight information system that utilizes solid-state sensor technology combined
with the power of four microprocessors to give an accurate and easy-to-understand display. To
ensure accuracy in its readings, it is very important that you install the unit correctly and perform
the specified calibration steps. This installation guide will help you through that process.
TOOLS AND EQUIPMENT
Included
The following parts are included with your EFIS-D10 purchase.
• 1 EFIS-D10 main unit
• 4 mounting nuts
• 4 washers
• 1 User Manual
• 1 Installation Manual
Optional
The following parts may or may not be included with your EFIS-D10 depending on which
options you selected when you purchased your unit.
• 1 Internal emergency battery (already installed, if ordered)
• 1 Pitot tube
• 1 Pitot mounting kit
• 1 EDC-D10 Electronic Digital Compass
• 1 External outside air temperature (OAT) sensor
• 1 Flush mount bracket