Installation Guide Owner manual

Instrument Installation
Panel Location and Mounting
The diagram at right shows the outside
dimensions of the front bezel of the EMS-
D10. Note that the instrument is about
seven inches deep and the supplied
harness extends three inches more. Use
the dimensions (in inches) found on the
diagram to plan for the space required by
the instrument. Take the following
considerations into account when s
a mounting location for the EMS-D10
Avoid placin
electing
.
g the instrument near heater
0 C
t
options for mounting the
ket,
he
U e
y
.
ly be completed once all other physical and
electrical installations have been performed. This will ensure that last-minute adjustments will
not have to be made with the EMS-D10 mounted in the panel.
vents or any source of extremely hot or
cold air. Keep in mind that the air
surrounding the EMS-D10 during
operation may be no warmer than 5
to ensure accurate operation. Plan a
panel location that allows convenien
viewing of the instrument with no
obstruction.
You have two
EMS-D10 into your panel: standard or
flush. You may use the optional flush-
mount bracket, allowing the face
of the EMS-D10 to be flush with
your panel. If you opted to
receive the flush mount brac
please skip to Option 2 below. If
you opted not to receive this
bracket and wish to perform t
standard install, follow the
options in Option 1 below.
OPTION 1: NO MOUNTING
4-8 EMS-D10 Installation Guide
BRA
CKET
sing this option, you will b
mounting the EMS-D10 directl
into your panel. The front bezel
of the unit will extend beyond
the plane of your panel by 0.8”
Installation of the EMS-D10 main unit should on