Installation Guide Owner manual

EMS Configuration
GENERAL PURPOSE TEMPERATURE
Under the desired GP input number, set FUNCT to GP
TEMP. Select the analog bar thresholds as described in
the Alarm and Color Threshold Configuration on page 5-
2. Set the SENSOR TYPE to the correct number using
the senso
r type table.
Press DOWN▼ to select the LABEL 1 field. The first
character of the 4-character name is highlighted. Press
INC+ or DEC- to cycle through the numbers and letters
for the first character. When you have selected the
desired letter, press SEL► to move to the next character.
Repeat this for each of the characters in the contact name
field. If desired, repeat this for LABEL 2. If you leave LABEL 2 with its default “----” value, the
temperature units are displayed beneath the temperature bar’s label; otherwise, the value of
LABEL 2 is displayed.
Sensor
Type
GP Temp Sensor
Dynon P/N 100433-000
(2-w
ire)
Dynon P/N 100433-001
(3-wire, when installed
as described on page 3-
13)
1
2 GRT OAT-01
5-18 EMS-D10 Installation Guide