Installation Guide Owner manual

EMS Configuration
General Purpose Thermocouple
Select the alarm mode as described in the Alarm and
Color Threshold Configuration section on page 5-2.
Configure the GP therm
ocouple info bar to display in the
desired location(s), as described in the EMS-D10 Pilot’s
User Guide > Global Configuration Settings > Info Item
Configuration
section.
After configuring alarms, press DOWN▼ to select the LABEL 1 field. The first character of the
4-character name is highlighted. Press INC+ or DEC- to cycle through the numbers and letters
for the first character. When you have selected the desired letter, press SEL► to move to the
next character. Repeat this for each of the characters in the contact name field. If desired, repeat
this for LABEL 2. If you leave LABEL 2 with its default “----” value, the temperature units are
displayed beneath the temperature bar’s label; otherwise, the value of LABEL 2 is displayed. Set
the SENSOR TYPE to J or K, depending on the thermocouple type used.
Sensor
Type
GP Temp Sensor
J J Type Thermocouple
K K Type Thermocouple
5-20 EMS-D10 Installation Guide