Installation Guide User Manual

3. TRANSDUCER INSTALLATION
This section explains the steps required to install and connect all transducers supplied by Dynon
Avionics. Additionally, connection instructions are given for some transducers that Dynon
Avionics does not sell, like the tachometer, fuel level, flaps, trim, and contacts.
Tools and Equipment Required
The following list contains commonly used tools and equipment; however some of the tools or
equipment listed below may not apply to your installation.
 Wire strippers
 22 AWG wire (if harness not purchased or extending harness beyond 6 feet)
 D-sub pin crimper
 Faston/ring terminal crimp tool
o Available from www.bandcspecialty.com – [phone] – part number RCT-1
 Weather Pack crimp tool (common slip joint pliers will also work)
o Available from www.whiteproducts.com/tools.shtml
 #2 Phillips screwdriver
 Flathead screwdriver
 ¼” ID tubes, any necessary adapters, and clamps for routing manifold pressure to the
sensor.
 Drill and 1/8” bit
EMS-D120 Installation Guide 3-1