Installation Guide User Manual

EMS Configuration
COOLANT TEMPERATURE
Sensor
Type
Coolant Temp
Sensor
1 Dynon P/N 100409-001
Under the desired GP input number, set FUNCT to
COOL TEMP. Select the analog bar thresholds as
described in the Alarm and Color Threshold
Configuration section on page 5-2. Set the SENSOR
TYPE to the correct number using the sensor type table.
Chevrolet L
S7 pre-
installed
2
3 Dynon P/N 100409-000
COOLANT PRESSURE
4 Rotax 801-10-1
Under the desired GP input number, set FUNCT to
COOL TEMP. Select the analog bar thresholds as
described in the Alarm and Color Threshold
Configuration section on page 5-2. Set the SENSOR
TYPE to the correct number using the sensor type table.
Sensor
Type
Coolant Pressure
Sensor
1 Dynon P/N 100411-000
OUTSIDE AIR TEMPERATURE SENSOR
Sensor
Type
OAT Sensor
Under the desired GP input number, set FUNCT to OAT.
Select the analog bar thresholds as described in the Alarm
and Color T
hreshold Configuration section on page 5-2.
Set the SEN
SOR TYPE to the correct number using the
sensor type table.
1
Dynon P/N 100433-000
(2-w
ire)
Dynon P/N 100433-001
(3-wire, when installed
as described on page 3-
13)
2
If you have installed a D
ynon Avionics OAT to a General
Purpose Input enter the EMS setup menu by pressing
SETUP > SENSOR > EMS GP INPUT. Set the desired
GP Input to OAT and select sensor type 1.
GRT OAT-01
Do not set the sensor type in the EFIS > SETUP >
OAT menu on any DSAB-connect EFIS instruments. Ensure that the INSTALLED value
in the EFIS OAT menu is set to N.
AILERON TRIM
Under the desired GP input number, set FUNCT to TRIM AILRN. There are no alarm thresholds
or any other setting required for aileron trim.
ELEVATOR TRIM
Under the desired GP input number, set FUNCT to TRIM ELEV. There are no alarm thresholds
or any other setting required for elevator trim.
RUDDER TRIM
Under the desired GP input number, set FUNCT to TRIM RUDR. There are no alarm thresholds
or any other setting required for rudder trim.
FLAP POSITION
Under the desired GP input number, set FUNCT to FLAP POS. There are no alarm thresholds or
any other setting required for flap position.
EMS-D120 Installation Guide 5-17