Installation Guide Instruction Manual

Appendix
FlightDEK-D180 Installation Guide 9-21
the assigned NAV2 in the source cycle, and so on for as many other NAV
the above procedure for all configured GPS inputs in the GPS ORDER menu.
following points describe the options
ets
The “direct” audio output of the
EF
e
4
udio output is m
uted*.
e
input you wish to be
radio inputs.
Repeat
Voice/Tone Alert Configuration
The HS34 can act as the sole audio alert
source for all DSAB-connected Dynon
instruments. The HS34’s audio output
reports both EFIS and EMS alerts; each
type of alert can be configured to be either
voice or tone formats. When the HS34 is
connected to your system, audible alerts are
still generated by both EMS- and EFIS-
based instruments. If you would like the
HS34’s audio out to be your only source
for Dynon product audible alerts,
disconnect the audio out connections on
your other DSAB-connected Dynon
products.
To configure HS34 audio alerts, enter the
EFIS > SETUP > HSI menu, scroll down to
AUDIO ALERTS, and press SEL►. The
available for each setting:
EMS: EXT TONE / EXT VOICE – S
whether you want the HS34 to report tones
or voice alerts during EMS alarm
conditions. This setting has no effect on the
“direct” audio output of the EMS.
EFIS: EXT TONE / EXT VOICE – Sets
whether you want the HS34 to report tones
or voice alerts during EMS alarm
conditions.
IS is muted*.
EFIS: EFIS TONE – tones are generated through the “direct” audio output of the EFIS and th
audio output of the HS34 is muted.
AOA: EXT TONE – During an AOA alarm condition, tones are generated through the HS3
audio output and the EFIS “direct” a
AOA: EXT VOICE – During an AOA alarm condition, voice is generated through the HS34
audio output simultaneously with a “progressive” tone from the EFIS “direct” audio output.
AOA: EFIS TONE – Tones are generated through the “direct” audio output of the EFIS and th
audio output of the HS34 is muted.
EMS AUDIO ALERTS
RPM HIGH
MANIFOLD PRESSURE HIGH
OIL PRESSURE HIGH/LOW
OIL TEMPERATURE HIGH/LOW
EGT [1..6] HIGH/LOW
EGT SPAN
CHT [1..6] HIGH/LOW
CHT SPAN
CHT [1..6] SHOCK
FUEL LEVEL [1..4] LOW
FUEL PRESSURE HIGH/LOW
FUEL FLOW HIGH
VOLTAGE HIGH/LOW
CURRENT HIGH/LOW
COOLANT TEMPERATURE HIGH
COOLANT PRESSURE HIGH/LOW
All other EMS alerts vocalized “EMS ALERT”
EFIS AUDIO ALERTS
ALTITUDE (Altitude alerter)
CLIMB/DESCEND (Altitude alerter)
AUTOPILOT DISCONNECT
STALL
TIMER EXPIRED
DSAB ERROR