Installation Guide Instruction Manual

Instrument Installation
EFIS SERIAL HARNESS
On the EFIS 25-pin wiring harness
available from Dynon, there are three
wires bundled together, terminating in a
standard DB9-pin female connector. This
cable is 6’ long and pre-assembled for
connection to a PC-based laptop. Route
this cable to a convenient location that can
be accessed whenever you need to update
your product’s firmware or checklists.
If you did not purchase a harness from
Dynon, obtain a 9-pin D-sub connector and make the three connections shown in the table.
To verify proper communication between the FlightDEK-D180 and the PC, use the Dynon
Avionics Product Support Program’s “Detect Firmware Version” function. Download the latest
version of the Support Program from the Dynon Web Site at downloads.dynonavionics.com.
EMS SERIAL HARNESS
On the EMS 37-pin wiring harness available
from Dynon, there are three wires bundled
together, colored orange, yellow, and black, and
terminating in a standard D-sub 9-pin female
connector. If you did not purchase a harness
from Dynon, obtain a 9-pin D-sub connector
and make the three connections shown in the
table.
EFIS
DB25
Pin#
DB9
Pin#
Wire
Color
RS-232 Function
9 5 Black Signal ground
10 2 Orange FlightDEK-D180
transmit / PC receive
22 3 Yellow FlightDEK-D180
receive / PC transmit
EMS
DB37
Pin#
DB9
Pin#
Color Function
11 2 Orange
EMS Tx /
device Rx
12 3 Yellow
EMS Rx /
device Rx
30 5 Black RS232 Ground
FlightDEK-D180 Installation Guide 4-5