Installation Guide Instruction Manual

EMS Configuration
General Purpose Inputs
In each of the 3 EMS GP INPUT submenus,
you must select the function corresponding to
the sensor that is installed for the respective
GP connection. Ensure that you have
configured your info items on the main and
aux pages to display the desired GP inputs.
Note that each GP menu will have help text,
reading “DISPLAYED: INFO #” for each
info item position where the given GP
parameter is displayed. If the given info item
is not configured to display anywhere, no text
will be shown. Configure the info item (bar, text, or flaps/trim) for each GP input to display in
the desired location(s)s, as described in the FlightDEK-D180 Pilot’s User Guide > Global
Configuration Settings > Info Item Configuration
section.
The General Purpose Inputs listed below the HS34 INPUTS section, (HS34 GP INPUT 1,
2, 3) can only be used with an HS34 installed and configured
We recommend that you set the FUNCT for all unused GP inputs to UNUSED.
ROTAX CHT
Select GP INPUT 1 and press SEL► to change the FUNCT parameter to ROTAX CHT L. Back
out and select GP INPUT 2 and press SEL► to change the FUNCT parameter to ROTAX CHT
R. Refer to the Cylinder Head Temperature (CHT) setup section on page 6-11 for information
about changing the various CHT-related param
eters.
RESISTIVE FUEL LEVEL
Under the desired GP input number, set FUNCT to FUEL LVL 3 or FUEL LVL 4 (if FUEL
LVL 3 has already been chosen on a different GP input). All fuel level inputs use the same alarm
settings. Configure these as described in the Alarm and Color Threshold Configuration section
on page 6-2.
CARBURETOR TEMPERATURE
Sensor
Type
Carburetor Temp Sensor
1
Dynon P/N 100413-000
(with black wires)
2 GRT CARB-01
3
Dynon P/N 100468-000
(with white/black wires)
Under the desired GP input number, set FUNCT to
CARB TEMP. Select the analog bar thresholds as
described in the Alarm and Color Threshold
Configuration section on page 6-2. Set the
SENSOR TYPE to the correct num
ber using the
sensor type table.
6-16 FlightDEK-D180 Installation Guide