Installation Guide Instruction Manual

EMS Configuration
COOLANT TEMPERATURE
Sensor
Type
Coolant Temp
Sensor
1 Dynon P/N 100409-001
2
Chevrolet LS7 pre-
installed
3 Dynon P/N 100409-000
4 Rotax 801-10-1
Sensor
Type
Coolant Pressure
Sensor
1 Dynon P/N 100411-000
Sensor
Type
OAT Sensor
1
Dynon P/N 100433-000
(2-wire)
Dynon P/N 100433-001
(3-wire, when installed
as described on page 3-
13)
2 GRT OAT-01
Under the desired GP input number, set FUNCT to
COOL TEMP. Select the analog bar thresholds as
described in the Alarm and Color Threshold
Configuration section on page 6-2. Set the SENSOR
TYPE to the correct number using the sensor type table.
COOLANT PRESSURE
Under the desired GP input number, set FUNCT to
COOL TEMP. Select the analog bar thresholds as
described in the Alarm and Color Threshold
Configuration section on page 6-2. Set the SENSOR
TYPE to the correct number using the sensor type table.
OUTSIDE AIR TEMPERATURE SENSOR
Under the desired GP input number, set FUNCT to
OAT. Select the analog bar thresholds as described in
the Alarm and Color Threshold Configuration section on
page 6-2. Set the SENSOR TYPE to the correct number
using the sensor type table.
If you have installed a D
ynon Avionics OAT to a
General Purpose Input enter the EMS setup menu by
pressing SETUP > SENSOR > EMS GP INPUT. Set the
desired GP Input to OAT and select sensor type 1.
If the OAT is connected to the EMS D37
connector, do not set the sensor type in the EFIS > SETUP > OAT menu. Ensure that the
INSTALLED value in the EFIS OAT menu is set to N.
AILERON TRIM
Under the desired GP input number, set FUNCT to TRIM AILRN. There are no alarm thresholds
or any other setting required for aileron trim.
ELEVATOR TRIM
Under the desired GP input number, set FUNCT to TRIM ELEV. There are no alarm thresholds
or any other setting required for elevator trim.
RUDDER TRIM
Under the desired GP input number, set FUNCT to TRIM RUDR. There are no alarm thresholds
or any other setting required for rudder trim.
FLAP POSITION
Under the desired GP input number, set FUNCT to FLAP POS. There are no alarm thresholds or
any other setting required for flap position.
FlightDEK-D180 Installation Guide 6-17