Installation Guide Instruction Manual

Autopilot Installation and Configuration
FlightDEK-D180 Installation Guide 8-15
 Enter the EFIS > SETUP > DSAB > CONFIGURATION menu.
ARE YOU SURE YOU WANT TO RE-CONFIGURE THE NETWORK?
 Press YES
ARE ALL NETWORKED DEVICES POWERED ON?
 Press CONFIGURE NOW
PLEASE WAIT DETECTING ALL NETWORK DEVICES
 Wait up to 1 minute
(X) DEVICES FOUND NETWORK CONFIGURATION IS COMPLETE
shows the correct nu
 Verify that this
expected devic
mber of devices. If not, check wiring and ensure that all
e
ly
is already at version 5.4 firmware.
til this procedure is completed,
es are powered on.
 Press FINISH
d be  Press UP▲ > and then SEL► to select the STATUS menu. The Bus Master EFIS shoul
displayed, showing active roles and status. Verify that STATUS (at bottom) shows ACTIVE.
 Press DOWN▼ once for each device in the network. Verify that the STATUS for each
device shows ACTIVE.
If the status displays UPGRADE REQ, that instrument must b
updated to the same version of firmware as the Bus Master EFIS. If the instrument
displaying UPGRADE REQ is one or more of your servos and/or AP74 (most common
your EFIS), you must perform the when these devices were purchased separately from
upgrade via the Bus Master EFIS, even if the EFIS
 After the above verification, press BACK > EXIT
STEP 2 - SERVO CALIBRATION AND SERVO TEST
The Servo Calibration procedure identifies the orientation and range of motion of each servo.
The Servo Test procedure verifies that each servo is configured properly by moving the control
surfaces, and requiring the pilot to verify correct movement. Un
the EFIS does not display the AP status or operation interface.
If Airspeed Color Thresholds have not been configured, Servo Calibration and Servo T
cannot proceed, and the EFIS displays an error message. To configu
est
re Airspeed Color
;
ration, the SERVO TEST procedure can be performed on its own
has been installed, skip the non-applicable
Thresholds, see Configure Airspeed Color Thresholds on page 5-4.
Note: Servo calibration (SERVO CAL) and servo test (SERVO TEST) is a combined procedure
when Servo Calibration is completed successfully, you are prompted to perform Servo Test.
After a successful servo calib
whenever desired.
Note: The following steps assume that two servos are installed to provide AP control of Pitch
and Roll functions. If only a Pitch or Roll servo
sections.
On the EFIS, perform the following:
 Enter the SETUP > AP > SERVO CALIB menu.