User's Guide

Com Radio Operation
SkyView HDX Pilot’s User Guide – Revision G 9-11
• Use the dual concentric knob to type an airport identifier. Note that this search is
limited to airports within 75 miles of your location to speed up entry by limiting the
airport possibilities:
o The small, inner knob chooses characters (A-Z, 0-9).
o The larger, outer knob moves the cursor:
• When the desired airport is displayed, press the dual concentric knob on the control
panel to load the airport to the control panel (or press APT to cancel your selection).
• Use the TWR, ATIS, GND, and ATC buttons to send the associated airport frequencies
to the standby frequency location.
Using the TWR, ATIS, GND, and ATC Buttons
When an airport is loaded on the radio, press the TWR, ATIS, GND, and ATC buttons to send
frequencies associated with that airport to the standby frequency. Repeated presses of these
buttons will cycle through all available frequencies of that type (for example busy airports may
have multiple tower frequencies):
• TWR: Tunes tower, Unicom, and Multicom frequencies.
• ATIS: Tunes ATIS and other weather/information frequencies, including AWOS,
ASOS, AWIB, and AWIS frequencies.
• GND: Tunes ground control frequencies.