User's Guide

Com Radio Operation
9-6 SkyView HDX Pilot’s User Guide – Revision G
• Turn the small, inner ring of the dual concentric knob to change the standby
frequency. The SV-COM-X25 and SV-COM-C25 adjust in 25 kHz increments and by
either 25kHz or 8.33kHz increments on the SV-COM-X83 (depending on how it is
configured).
o For example, if the frequency you start with is 123.450, turning the large knob
will change the numbers before the decimal – 123 – while the small knob will
adjust the numbers after the decimal – 450.
• Press the dual concentric knob on the control panel to flip/flop the chosen
frequency from the standby frequency to the active frequency.
Airport / Station Type Reverse-Lookup
When a frequency is manually tuned, SkyView will search for the closest known airport within
75 miles that has that frequency and automatically show that airport’s identifier in the
associated airport and station type fields on both the control panel and top bar.
For example, if you manually tune 118.300 near Seattle’s Boeing Field, the associated airport
will be shown as KBFI and the station type as TWR1:
Tuning Individual Frequencies from SkyView HDX
To send an individual frequency from SkyView HDX’s airport information pages:
• Select the INFO page for an airport.
• Then, use the knob to select a frequency from under the COM tab: