User's Manual

Document Number 001
DOC
–
Wifi Module Installation
Guide
Revision
006
© Dyson Technology Limited 2015
2
1. Installation of the Radio Module
The device WIFIAMFA001 is only used in Dyson products. This module is factory mounted in the Dyson
Environmental Products.
This module is not supplied to the end user on its own and the WIFIAMFA001 module will only be
installed or replace on the end products by Dyson Engineers. As such a simple installation guide is given
for reference only.
2. Compliance Statement
FCC (Federal Communications Commission) statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) The device may not cause harmful interference, and
2) The device Module must accept any interference received, including interference that may cause
undesired operation.
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. The
antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm
from all persons and must not be co-located or operating in conjunction with any other antenna or
transmitter.
Important Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
This transmitter must not be co-located or operating in conjunction with any other antennas or
transmitters.
It is the responsibility of the host device manufacturer to ensure continued compliance with FCC rule part
15B once the module has been installed in the host device.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
The concerned end product must be labelled to say
“Contains FCC ID: QVHWIFIAMFA001”
Industry Canada statements
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
1) The device may not cause interference, and
2) The device must accept any interference, including interference that may cause undesired operation of
the device.
Important note: To comply with Industry Canada RF exposure limits, the antenna used for this device
must be installed to provide a separation distance of at least 20cm from all persons.
RF exposure is in accordance with RSS-102, section 2.5.2.
The concerned end product must be labelled to say
“Contains IC: 7986A-WIFIAMFA001”