SDS

Page 6/7
Dyson Battery Pack 6-Cell (225403)
Revision: 06
Revised date: 29-January- 2020
ADR
ICAO-IATA/ DGR
IMDG-Code
ADN
2) Section II applies to lithium ion batteries with a Watt-hour rating not exceeding 100 Wh
packed in quantities not exceeding the allowance permitted in Section II, Table 965-II
3) Each package must capable of withstanding a 1.2m drop test in any orientation without:
- damage to batteries contained therein;
- shifting of the contents so as to allow battery to battery ( or cell to cell) contact;
- release of contents
4) Each package must be labelled with a lithium battery handling label
UN 3480, PI 965, Section IA and IB. Lithium ion cells and batteries must be offered for
transport at a state of charge (SoC) not exceeding 30% of their rated design capacity.
Cells and/or batteries at a SoC of greater than 30% may only be shipped with the
approval of the State of Origin and the State of the Operator under the written conditions
established by those authorities.
UN 3480, PI 965, Section IA and IB are forbidden for carriage on passenger aircraft. All
packages must bear the Cargo Aircraft Only label in addition to the other marks and labels
required by the Regulations
UN 3480, PI 965, Section II. Lithium ion cells and batteries must be offered for transport
at a state of charge (SoC) not exceeding 30% of their rated design capacity.
All packages prepared in accordance with Section II of PI 965 are forbidden for carriage
on passenger aircraft. All packages must bear the Cargo Aircraft Only label in addition to
the other marks and labels required by the Regulations.
A shipper is not permitted to offer for transport more than one (1) package prepared
according to Section II in any single consignment. Not more than one (1) package
prepared in accordance with Section II of PI 965 may be placed into an overpack. When
the package is placed in an overpack, the lithium battery handling label and Cargo
Aircraft Only label required by this packing instruction must either be clearly visible or
the label must be affixed on the outside of the overpack and the overpack must be
marked with the word “Overpack”.
Lithium ion batteries packed with equipment - Lithium ion batteries in compliance
with Section of PI 966
1) Section II applies to lithium ion batteries with a Watt-hour rating not exceeding 100 Wh
Lithium ion batteries contained in equipment - Lithium ion batteries in compliance
with Section of PI 967
1) Section II applies to lithium ion batteries with a Watt-hour rating not exceeding 100 Wh