Use and Care Manual

8 9
1 2 3
4 5 6
7
6 sec
clik clik
Clean the hatch every time the filter is
replaced. Open the small hatch on the side
of the machine. Use a cotton swab to clean
inside and remove any debris. This maintains
sensor accuracy and ensures the continuing
high performance of the machine.
Look for blockages in the small aperture inside the loop amplifier.
Use a soft brush to remove debris.
Ensure the machine is unplugged. Dust may
accumulate on the surface of the machine.
Wipe dust from the loop amplifier, filter unit
and other parts with a dry or damp cloth
when dust accumulates.
Press buttons to lift off loop amplifier and lift off filter.
Ensure the machine is unplugged. Look for blockages in the
air inlet holes on the filter. Use a soft brush to remove debris.
Look for blockages in the air inlet holes under the filter and use a soft
brush to remove debris. Replace the filter and then the loop amplifier.
Do not use detergents or polishes
to clean the machine.
Clearing blockages
Cleaning
When your non-washable filter unit needs
replacing the machine will display the pattern
shown. To replace the non-washable filter unit,
follow these steps. Ensure your machine is
unplugged. Your Dyson machine is programmed
to remind you to replace the filter unit after 12
months based on 12 hours usage a day. Please
note your indicator will activate sooner with more
use. The indicator is only a guide and you may
need to replace the filter unit more regularly.
A clockwise-rotating loading pattern
will be shown on the LED display.
Once the loading pattern is complete, the
appliance will return to its normal usage.
When you have re-assembled your appliance, press and hold
the 'Standby ON/OFF' button for 6 seconds.
Replacing the filter unit