Specification Sheet

For further information please contact Dyson
888-397-6622
[e-mail]
www.dyson.com
Electrical
Input voltage: Low voltage = 100-127V, High voltage = 200-240V
Frequency: 50 or 60Hz at 100-127V;
50 or 60Hz at 200-240Hz
Standby power consumption: Less than 0.5 W
Motor specification: 900 W (MAX) mode / 650 W (ECO) mode
digital brushless motor
Motor switching rate: 5,000 per second (MAX mode) / 4,533 per second
(ECO mode).
Amp: Dedicated 20 AMP suitable for up to 2 machines
LV: 5.91 AMP (ECO) / 7.79 AMP (MAX) HV: 2.95 AMP (ECO) / 4.05 AMP (MAX)
Heater type: None
Construction
Fascia: Stainless steel – Brushed (304L)
Backplate mounting bracket: Stainless steel
Exterior screw type: Anti-tamper 1
3
/
4
in Pin-Hex
Water ingress protection to IP24
Filter
Sealed HEPA filter (Glass fiber and fleece prelayer)
Removes 99.97% of particles, as small as 0.3 microns, including bacteria and viruses.
Operation
Touch free ‘time of flight’ sensor activation
Hand dry time measurement: 10 seconds (MAX) mode / 12 seconds (ECO)
mode (measurement based on NSF P335 to a measurement of 0.1g
residual moisture)
Sound power level: 79 dB(A) (MAX) mode / 77 dB(A) (ECO) mode
Operation lock-out period: 30 seconds
Airspeed at aperture: 624km/h or 388 mph (High voltage Max mode);
569 km/h or 354 mph (High voltage Eco mode); 624 km/h or 388 mph
(Low voltage Max mode); 543 km/h or 337 mph (Low voltage Eco mode)
Maximum altitude: 3,000 meters / 9,842 ft
Operating temperature range: 32°F–104°F / 0°C–40°C
Logistics
Single unit order code: Low voltage: 282997-01, High voltage: 314696-01
Unit barcode:
Low voltage: 885609017693, High voltage: 885609017686
Net weight: 9.99 lbs / 4.53 kg
Packaged weight: 16.84 lbs / 7.64 kg
Packaged dimensions:
(H) 5.1 in x (W) 20.5 in x (D) 24.3 in / (H) 129 x (W) 520 x (D) 616 mm
Standard warranty
5 year parts and 5 year limited labor warranty
Dyson backplate
Where only unsupported plasterboard is available for installation,
a Dyson backplate must be used. The Dyson backplate helps
protect the wall from water damage and can be used to cover
holes/marks left from previously installed products – including
the Dyson Airblade dB hand dryer. Contact the Dyson Helpline
or www.dyson.com for further information.
WELL Building Standard™
Dyson Airblade™ hand dryers contribute towards satisfying
Feature W08 under the WELL Building Standard.™
The Carbon label is a trademark of the Carbon Trust.
Quiet Mark is a registered trademark of the Noise Abatement Society.
International WELL Building Institute™ and the related logo are trademarks
used with permission from the International WELL Building Institute.™
1
HEPA filter tested to IEST-RP-CC001.6, by an independent testing laboratory, under prescribed test conditions.