Owner’s Manual Please read this guide carefully before use.
Important safety instructions Please read this guide carefully before use.
Assembling your DCO7 Box contents Wand Hose 2 1 Stair tool Brush tool Assembling your DCO7 Crevice tool This machine was inspected and packaged carefully before being shipped from the factory. Animal turbo tool Supplied with certain models only, or available as an accessory. Floor tool Supplied with certain models only, or available as an accessory. 4 If you need assistance during assembly or operation, please call the Dyson Helpline on 1- 866 - 693 - 9766.
Assembling your DCO7 3 3 Slide the wand into the top of the machine until it clicks securely into place. You may need to press firmly and should hear a ‘click’ sound. 4 4 Push the brush and stair tools securely into the storage holes on either side of machine. Fit the crevice tool into the tool clip on the back of the wand. 5 5 Store the cord safely by winding counter-clockwise around the cord winders and securing with the cord clip.
Using your DCO7 Using your DCO7 WARNING • To reduce the risk of electric shock and personal injury, this appliance has a polarized plug (one blade wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not force the plug into the outlet. Do not alter the plug in any way.
Using your DCO7 1 2 Transporting your Dyson Carrying your DCO7 Brush control system To move the machine from room to room, ensure it is upright, with the cord stored on the cord winders and the wand securely in place. Tilt back on the rear wheels and push forward. Your DCO7 should be lifted by using the carry handle. Ensure the machine is in an upright position before adjusting the setting. CAUTION • Do not shake the machine when carrying.
Using the tools Using the tools A Choosing the right tool The tools allow you to clean surfaces above the floor and to reach hard to clean areas. Ensure the machine is in an upright position before using tools. B A Brush tool – with soft bristles to dislodge dust and cobwebs. The brush head twists to make cleaning easier. 2 B Stair tool – with velour strips to pick up hairs and an agitating edge to lift the carpet. The tool channels airflow downward for better pick-up without sticking to upholstery.
Using the tools Hose mode Reversed wand mode Stair cleaning Press the wand release button and remove the wand. Fit one of the tools directly on to the end of the hose. Use tools for confined spaces such as car cleaning. Reverse the wand and click into the end of the hose, pressing the wand release button to ensure a correct fit. Fit one of the tools on to the end of the wand. Use tools for easier handling in hard to reach areas. Use the hose and stair tool or turbo tool for stair cleaning.
TM Emptying the clear bin Emptying the clear bin A TM CAUTION A • Disconnect the machine from the electrical outlet before emptying the bin. Failure to do so could result in electric shock or personal injury. B B To ensure your machine continues to clean effectively, the clear bin must be emptied when the dust reaches the MAX mark. Press the cyclone release catch with your thumb to remove the clear bin assembly from the machine.
C The British Allergy Foundation is a UK national charity with the aim of improving awareness, prevention TM and treatment of allergies. The British Allergy Foundation Seal of Approval is a UK registered trademark. B D Shroud cleaning (when necessary) To remove any build-up of lint or large dust particles on the shroud: Ensure the clear bin is empty and the clear bin base is open. A Press the bin release catch to remove the clear bin.
Cleaning the lifetime filter Cleaning the lifetime filter 1 CAUTION • Disconnect the machine from the electrical outlet before removing filter. Failure to do so could result in electric shock or personal injury. 2 B A A Lifetime pre-motor filter Rinse at least once every six months in accordance with the instructions opposite. If machine is regularly used for vacuuming very fine dust such as plaster dust or carpet fresheners, you may need to rinse more often.
Cleaning the lifetime filter 4 5 6 3 7 2 1 Only the blue foam pad and the yellow cage should be rinsed – not the filter housing. 4 Rinse the blue foam pad and squeeze gently, repeating until the water runs clear. 3 Submerge the filter and cage in cold water and rinse thoroughly. 5 Rinse the yellow cage and tap firmly, repeating until the water runs clear. CAUTION • Rinse in cold water only. • Do not use detergent. • Do not put in a washing machine or dishwasher.
