KH2027_2028_IB_UK_V6 20.02.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 2 UK Kompernaß GmbH · Burgstraße 21 · D-44867 Bochum www.kompernass.com ID Nr.
KH2027_2028_IB_UK_V6 20.02.
KH2027_2028_IB_UK_V6 20.02.
KH2027_2028_IB_UK_V6 20.02.
KH2027_2028_IB_UK_V6 20.02.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 3 KH 2027 KH2028 Digital World Receiver 1. Intended Use 2. Technical Data 3. Safety Instructions 4. Power Supply 5. Switching On / Off 6. Receive Mode 7. Memory 8. Clock and Timer 9. Miscellaneous 10. Troubleshooting 11. Cleaning 12. Disposal 13.
KH2027_2028_IB_UK_V6 20.02.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 5 KH 2027 KH 2028 Digital World Receiver 2. Technical Data 1. Intended Use a) Environmental limits Temperatures: -5 – +40 °C Relative humidity: 20 – 80% RMH b) Reception ranges FM: 87.5 – 108.5 MHz AM Europe: 522 – 1656 KHz AM USA: 520 – 1710 KHz SW: 5.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 6 KH 2027 KH 2028 Tuning range: Sensitivity: 3. Safety Instructions FM 100KHz / 50KHz AM Europe 9KHz /1KHz AM USA 10KHz /1KHz SW 5KHz /1KHz LW 1KHz SW 2 levels selectable Transportable world receivers are used in a wide range of climate zones. Particularly when outdoors, take note that ... c) Other Memory positions: 250 stations Timer: 2 Alarm Times 1-59 min. snooze timer Date-specific Timer 90 min.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 7 KH 2027 KH 2028 4. Power Supply Transportable devices are particularly at risk of accidental damage. You can reduce this risk by paying attention to the following: Important: Make certain that the polarity is correct – both for the batteries as well as for the external power supply. If the polarity is reversed, the device will be damaged. Protect the device against heavy stresses, such as impacts and falls.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 8 KH 2027 KH 2028 5. Switching On / Off b) External Power Supply Connect the power supply adapter DC 6.V / 400 mA to the power supply jack. Note: The radio station memory described in section 7 will be deleted if the device is without power supply for more than approx. 30 seconds.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 9 KH 2027 KH 2028 6. Receive Mode c) Switching Off with Time Delay If you would like to listen to the radio for a while longer, for instance before falling asleep, but would like the device to switch off automatically after a certain amount of time (10...90 minutes), ... As soon as the device is switched on as described under 5., it is already in receive mode. a) Setting the Volume Press the buttons Volume Control, to adjust the volume.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 10 KH 2027 KH 2028 c) Changing the Medium Wave Range The frequency range and tuning intervals of AM vary by region: Region “Europe”: (9KHz) Region “USA”: (10KHz) When the device is switched off, and the date and time appear alternatively in the display: Press the key MODE repeatedly until EU 9k appears in the display. Press the lower key TUNING. US 10K appears in the display. press the upper key, TUNING. EU 9k appears again in the display.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 11 KH 2027 KH 2028 Press the button Fine Set. In the display FINE appears. g) Sensitivity and Antenna Use the telescope antenna for FM and short wave SW. You can alter the reception strength by adjusting the length, inclination and direction of the antenna. Now press one of the two TUNING buttons, to raise or lower the frequency in small steps. A ferrite antenna is built into the device for medium wave (AM) and long wave (LW) reception.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 12 KH 2027 KH 2028 This division into blocks is useful to allow the stations to be saved according to a meaningful organisation principle. For instance ... - by type: music, news, sports - by location: local stations or frequently visited travel destinations - by person: if multiple family members use the device a) Saving radio stations (e. g. FM) When you have found a station that you would like to save: Press the button Memory Set.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 13 KH 2027 KH 2028 Note: These buttons each have two assignments. Each press on them switches between the two assignments (e.g. between 0 and 5). When you have selected the desired memory position, Press the button Memory Set again. The station is now saved. b) AMS function The device has an automatic transmission storage. Press the button Memory Set. Press and hold the button Memory Preview for two seconds, to activate the AMS function.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 14 KH 2027 KH 2028 Note: These buttons each have two assignments. Each press switches between the two assignments (e.g between 0 and 5). d) Memory scan mode If you have saved multiple stations: First of all select the Band (Reception range), e. g. FM. Press the button PAGE repeatedly until you see, in the small window PAGE, the number for the block 0...5, in which you want to start the search mode. Press once briefly on the button Memory Preview.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 15 KH 2027 KH 2028 Press the button MODE. The time now blinks in the display. Briefly press one of the TUNING buttons to set the time by minute. Hold one of the TUNING buttons pressed to set the time in 10 minute steps. b) Setting the date Press the button MODE repeatedly until the date blinks in the display. Briefly press one of the TUNING buttons to set the date by day.
KH2027_2028_IB_UK_V6 20.02.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 17 KH 2027 KH 2028 e) Setting Travel Destination Time Regions Once you have selected a home time region as described under d): Press the button MODE until only CITY appears in the display. Use the TUNING buttons to select the travel destination from the same table, as used previously under d). The device now shows the time difference between the travel destination region and your home time region. After approx.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 18 KH 2027 KH 2028 g) Setting Alarm Times 1 / 2 When the device is switched off, and the date and time alternatively or just the time appear in the display: First select which of the two alarm times should be set. Press the button ... - ALARM 1 for alarm time 1 - ALARM 2 for alarm time 2 Once the respectively selected alarm time blinks in the display: Briefly press one of the TUNING buttons to set the alarm time by minute.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 19 KH 2027 KH 2028 Through renewed pressing and holding of the SNOOZE button you can change over to the programming of all weekdays. This is useful for working people who do not want to reset the alarm times after every weekend. If you would like to be woken by the radio, you should select the desired station and volume level before going to sleep. You can then simply switch off the device.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 20 KH 2027 KH 2028 The automatic repeat alarm is adjusted individually by 1-59 minutes. When the device is switched off, and the date and time alternatively or just the time appear in the display: Press the MODE button until SNO 10 or just the time appears in the display. Press the TUNING button to set the repeat alarm time minute-wise. Press the MODE button again. The repeat alarm time is now saved.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 21 KH 2027 KH 2028 Once an SDA alarm has been programmed, you can only deactivate it by repeating the configuration steps and programming in a date that is long past. j) Countdown Timer You can set and save different countdown times with the device. There are five storage spaces available. The radio mode must be switched off. Keep the Memory Preview button pressed for 2 seconds, until 00.00 appears in the display.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 22 KH 2027 KH 2028 Press the SNOOZE button again to start the stop watch. Press the SNOOZE button again to stop the stop watch. If you keep the SNOOZE key pressed for 2 seconds, the stop watch is reset to 0.00. 0u. Press the PAGE button to exit the stop watch function. The previously stored value is displayed. Press the SNOOZE button to start the countdown. Press the SNOOZE button again to pause the countdown.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 23 KH 2027 KH 2028 When the device is switched off, and the date and time appear in the display in alternation: Press the button Alt. Display repeatedly until the display shows ... - The symbol appears: When the device is switched off, only the time will be displayed. - DATE and appears: When the device is switched off, the time and date will be displayed in alternation.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 24 KH 2027 KH 2028 a) If something is not functioning If it does not react as described in this manual, remove all batteries and unplug any exernal power supply connected to the device for 2-3 minutes. Then replace the batteries or reconnect the external power supply. It should now function properly again. b) Additional problems? If the device still does not function as described above, a defect may be present. In this case, contact the customer service.
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 25 KH 2027 KH 2028 13. Warranty and service The warranty conditions and the serviceaddress can be found in the enclosed document. Kompernaß GmbH Burgstrasse 21 D-44867 Bochum www.kompernass.