User manual

ManualsBrandsE-BIKE VISION ManualsElectric BikesElectric bike battery charger Chargeur p

Manual fast-charger, suitable for Power Packs with 26 V and 6 A charge current

Page 1 of 6

Manual / Safety notes

for your E-Bike Vision fast-charger suitable for

Power Packs with 26 V

Power information:

for batteries with charge-end-voltage of 29.4 V with 6 A charge current

Charging method: CC/CV  ConstantCurrent- / ConstantVoltage method

Meassurements: 177 x 100 x 50 mm

Date: August 2016

Version: 03

E-Bike Vision GmbH

Am Neuen Berg 3

D-63755 Alzenau

fon: +49 (0) 6023 / 40590 - 22

fax: +49 (0) 6023 / 40590 - 25

mail: info@e-bike-vision.de

web: www.e-bike-vision.de

www.facebook.com/ebikevision

Summary of content (6 pages)

PAGE 1
Manual fast-charger, suitable for Power Packs with 26 V and 6 A charge current Manual / Safety notes for your E-Bike Vision fast-charger suitable for Power Packs with 26 V Power information: for batteries with charge-end-voltage of 29.
PAGE 2
Manual fast-charger, suitable for Power Packs with 26 V and 6 A charge current Read manual carefully before use! This manual is integral part of the product. It contains important information and safety notes. Keep it in range and give it away with the product to third party. Introduction We are glad, that you choose a charger of our product range. Please take some time to read this manual carefully.
PAGE 3
Manual fast-charger, suitable for Power Packs with 26 V and 6 A charge current CE declaration of conformity The evaluation of the device was carried out by European harmonized directives. You therefore have a product that is related to it’s construction meets the safety objectives of the European Community to the safe operation of equipment. The detailed CE declaration of conformity can be obtained from our service center. Scope of delivery 1. Charger with charge leads 2.
PAGE 4
Manual fast-charger, suitable for Power Packs with 26 V and 6 A charge current Functions - This charger is suitable to charge a 25.2 up to 25.9 Volt, Li-Ion battery pack, with 7 cells in serial. The max. charge current is 6 A max. - The charger has an overload, short circuit, overvoltage and wrong polarity protection. Overload protection (cut off if the output current is higher than 6.
PAGE 5
Manual fast-charger, suitable for Power Packs with 26 V and 6 A charge current Notes This charger has a wrong polarity protection. The right polarity is the base that the charger generates a charge voltage. Depending on the battery safety board, a battery pack that is discharged under it’s nominal discharge voltage can’t be charged again. In this case please contact E-Bike Vision GmbH. Error through short circuit or wrong polarity will be reset automatically maximum 1min after removing the Problem.
PAGE 6
Manual fast-charger, suitable for Power Packs with 26 V and 6 A charge current Datasheet Fast-Charger 7S 6 A for batteries with charge-end-voltage of 29,4 V Pack-configuration: 7S Li-Ion cells Charging method: CC/CV  ConstantCurrent / ConstantVoltage method Size: Length: 177 mm Width: 100 mm Height: 50 mm Weight: 890 g Input voltage range: 100 Vac bis 240 Vac Input current: max. 3 A Input frequency: 50 – 60 Hz Output voltage: 29,4 +/- 0,3 V Output current: max.