User's Manual
BT HEADPHONE
Package Contents:
 - 1 (One) Bluetooth headphone 
 - 1 (One) Charging cable 
 - 1 (One) Instruction Manual 
Button Description:
“ ”:ON/OFF/Pause/Play Music
 :Short press to increase volume / long press Next song
 ”:Short press to reduce volume / long press Previous song
How To Use:
• Power on: Press the center key “  ” 2 seconds when it is off. The blue LED 
 light will turn on, and begin to alternate blue/red LED light.  A voice will prompt “pairing”, 
 this indicates the headphone is in pairing mode.
• Pairing: Activate the bluetooth function on your phone within range and select 
 “BT Headphone” from the list shown.When the blue/red LED light stops flashing, it has 
 paired successfully and you will hear “connected”. The blue LED will flash slowly when 
 playing music. 
• Play/Pause: When it is playing, press the center key “  ” to pause, then press the 
 center key “ ” again to play. 
• Volume up: Press “+” once to increase the volume. 
• Volume down: Press “-” once to decrease the volume.
• Previous song: Hold down the “-” to play the previous song.
• Next song: Hold down the “+” to play the next song.
• 
Power off
: When the headphone is on standby or operating, press the center key “ ” 
 3 seconds to shut down the headphone (voice prompt “power off ”).
.
•
Phone Call: 
FCC statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
 following two conditions: 
 (1) this device may not cause harmful interference, and (2) this device 
 must accept any interference received, including interference that may cause 
 undesired operation.
 NOTE 
 This equipment has been tested and found to comply with the limits for a 
 Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
 designed to provide reasonable protection against harmful interference in a 
 residential installation. This equipment generates, uses and can radiate radio 
 frequency energy and, if not installed and used in accordance with the 
 instructions, may cause harmful interference to radio communications.
 However, there is no guarantee that interference will not occur in a particular 
 installation.If this equipment does cause harmful interference to radio or 
television
 reception, which can be determined by turning the equipment off and 
 on, the user is encouraged to try to correct the interference by one or more of the 
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which 
  the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
USB Plug Micro USB Plug
 result in damage to the product or injury.
• To avoid risk of shock or injury, do not dismantle the device or insert any 
 objects into the Heaphone.
• To avoid electronic interference and/or compatible conflicts, turn off the 
 product in any facilities where posted notices instruct you to do so.
• Do not pull the Heaphone charging cable. Damage may result to the cable.
• Keep out of reach of children. This is not a toy.
• Avoid exposure to moisture, liquids, heat, flame and high voltage equipment.
• Retain these instructions as they contain important information.
• Do not short circuit the input terminals of the Heaphone.
• Do not drop, place heavy weight or allow heavy impact to the Heaphone.
• 
• Do not use the product while driving or crossing the road.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. 
The device can be used in portable exposure condition without restriction.
FCC ID: 2AW5BMU01037 
Distributed by 1616 Holdings, Inc.
701 Market Street, Suite 200
Philadelphia, PA 19106
Made in China
Keep All Relevant Information For Future Reference
User Manual
 Paper:Writing Paper ; Paper Weight:0.15 Lbs
• Model Number: MU01037
• Range: 33ft / 10 m
• Battery Capacity: 200 mAh
• Voltage: 3.7 V 
• Play Time: 3-4 hours
• Charge Time: 2-3 hours
• Charging Way: USB DC 5V
• Frequency Response: 20Hz-20kHz
• Operating temperature range:0-45℃
FAQ:
1) Why can’t I start my Bluetooth headphone?
Answer: Please ensure that the headphone is fully charged for your first use.
2) Why won’t sound come out of the headphones?
Answer: Check whether the playback device and the Bluetooth headphone are 
successfully established. If the audio device is not properly connected,
please reconnect. Please also adjust your mobile phone or Bluetooth headphone 
volume to a suitable volume level.
3) Why can’t I find this headphone in my bluetooth options?
Answer: Make sure the Bluetooth is in “visible mode”. If no pairing occurs, the
Bluetooth function will automatically shut off. Please reopen Bluetooth to
“visible mode”. If there is a program error, please reboot your phone, and if a program 
error is caused by your Bluetooth headphone, please restart the headphone.
“    ”
“
Tips:
• Low Battery: LED light flashes red. 
• 
To Charge:
1. Insert the USB connector end of the included cable (see packing list) into the USB 
 jack on the charger or USB port on the computer.
2. The indicator light will be red while charging.
3. When the headphone is fully charged, the indicator light will turn from red to blue.
 Please unplug your charger from the power source.
4. Please use a qualified charger to recharge your headphone, If not, it may result in 
 damage or even explosion.
5. Repeated charging and discharging of the headphone will lead to decreased battery
 life over time, which is normal for rechargeable batteries.
6. You must charge the Bluetooth Heaphone if it has not been used for more than 6 
 months.
Technical Specifications:
+
-
WARNING:
WARNING:
 Changes or modifications to this unit not expressly 
 approved by the party responsible for compliance could void the user’s 
 authority to operate the equipment.
Next song / Volume Up
Previous song
 / Volume Down
On / Off / Play / Pause
• Charge and operate only as indicated in this manual, as improper use may
Press to answer/end a call.
Press and hold “ ” for about 1.5 seconds to reject an incoming call.
“ ” 
PCB of battery should not be crushed and twisted.
Battery body should not be Bended.
Do not disassemble and Do not dispose of in fire.
• 
• 
This product can expose you to chemicals 
including Bisphenol A (BPA), which is known
to the State of California to cause birth defects
or other reproductive harm. For more information,
go to www.P65Warnings.ca.gov.
WARNING:

